| PVC运动地板的安装步骤 |
| 添加时间：2018/12/15 15:29:01 浏览次数： |
| 1、铺设地面必须平整，干净。 1. The ground must be level and clean. 2、PVC运动地板在铺设之前，必须提前展开平铺在铺设地面25min以上， 2. Before laying the PVC sports floor, it must be spread out in advance and laid on the ground for more than 25 minutes. 且现场温度要高于15度。地板还原后，切割时两端应多留5厘米。粘贴前，将展开的地板反向卷起约一半，然后刮胶铺设—从中间开始—胶水用带齿的刮刀进行施工。 The field temperature is higher than 15 degrees. After the floor is restored, the two ends should be left 5 cm more when cutting. Before pasting, the unfolded floor is rolled up about half in reverse, and then the scraper is laid - starting from the middle - the glue is constructed with a toothed scraper. 3、按地板的编号顺序排好，对齐合并，注意铺装过程中场地线一定要对齐。 3. Arrange the floors in order of number, align and merge, and pay attention to the alignment of the site line in the course of paving. 4、沿合缝处翻开相邻的两片地板，将配套的专用连接带放在合缝处下侧，在连接带表面刷胶，先把一半连接带粘住其中一张板，然后将剩余的连接带粘在另一半上，缝隙要靠紧。 4. Open two adjacent floors along the joint, place the matching special connection belt on the lower side of the joint, brush glue on the surface of the joint belt, first glue half of the connection belt to one of the plates, then glue the remaining connection belt to the other half, the gap should be close. 5、注意使用对人体无害的水溶性胶水。地板粘贴时用软木块从中间向两端挤压地板表面使之不留气泡，保证平整。 5. Pay attention to the use of water-soluble glue which is harmless to human body. When the floor is pasted, cork blocks are used to squeeze the surface of the floor from the middle to both ends so as to keep no air bubbles and ensure the smoothness. 6、等地板铺粘合后进行开槽、焊接，焊接后要把焊线铲平。 6. After the floor is bonded, grooving and welding should be carried out. After welding, the welding wire should be leveled. |
| 上一页 运动地板 |
| 下一页 塑胶应用非常广泛 |
Copyright © 技术支持：遨游网络